1. our material is the key to the best quality !
2. Our quality control
Min tensile strength Mpa : 1000--1650Mpa
Max tensile strength Mpa : 1200--1900Mpa
Aperture square weave :2*2mm--100*100mm
Aperture tolerance :±3%
wire spur length : > wire diameter , < half of an aperture .
Finished wire is inspected by the third party SGS .
Screen length and width tolerance : ±5mm
Screen squareness tolerance is controlled within 1.5mm every 300mm length .
1,Precision mesh opening and good sieving effect.
2,Good abrasion resistance and a long service life.
3,Smooth surface and stable structure.
4,Pre-bending process and good tensile strength.
WEAVING TYPES OF VIBRATING SCREEN
EDGE TYPES OF VIBRATING SCREEN
|Screens for classifying, sizing, straining, sieving, are typically secured to a vibrating deck by clamping rails that apply tension across the screening surface. The tension is applied through edge treatments on the woven wire cloth screen panel commonly referred to as "hooks" , "hook strips" or "hooking strips".
|Proper screen tension is crucial for effective screening and longer screen life.
Banded edges prevent flattening of hook edges and eliminate mesh pull-out on fine wire mesh or high tension screens.
Products Daily maintenance:
1. Before running
(1) to check coarse mesh and fine mesh if there is a damage.(2) each group clamps is locking.
(1)notice any abnormal noises.(2)electric current is stable. (3)whether the vibration is abnormal.
3. After running
(1)after used clean up the vibration every time.
(2) inspect regularly the coarse mesh, fine mesh and the spring if there are fatigue and damage.
(3)whether each part of the vibrating body caused damage due to vibration.
(4)need to add the site to be the lubricating oil.
Packaging & Shipping
Packing: 1) water-proof paper+ poly film + label
2) water-proof paper+ poly film + label+plastic bag
3) poly film + label+ pallet.
Shipping: it's transported by container and ocean ship.
Mesh aperture tolerance: -3%~3%
Wire spur:>wire diameter,<half of an aperture
Diagonal deviation:(1) for the narrow and long, wide and long mesh (length > 2m), allows the diagonal error between 0 - 12mm;
(2) for short, wide and short mesh (length < 2m), allows the diagonal error between 0 - 9mm;
Mesh tightness judgment: pinch wire head weft, weft wire to ensure at the edge of a slide in the second warp filaments without sliding as appropriate, if not the net surface in boundary screw tight.
Do not allow the quality defects: the wrong size, not straight Jingwei, uneven net surface, loose net surface , too tight mesh net surface, exceed standard, jump flower short head.
According to the working requirement of precise cutting of products.
Check the diagonal and mesh size and then eliminate substandard products.
They have got high application in following :
Paper and pulp
Cement and stone crushing
Iron ore and steel industry
contact us :
Sales manager : alisa
Mobile : +86 18730291422